Desain Dan Analisa Pembebanan Statik Terhadap Kekuatan Pelek Modifikasi Tipe Cast Wheel Pada Sepeda Motor Menggunakan Software Solidworks

Muslimin Muslimin, Yuspian Gunawan, Budiman Sudia

Abstract


In the automotive world, there have been many accidents caused by plastic
deformed rims. The purpose of this study was to design and analyze static loading on the modified rim strength of the cast wheel type on a motorcycle. The analytical method used to analyze is by using Solidworks software, analysis of static loading simulation to be carried out with 3 variations of the rim model and 3 variations in the number of spokes (8, 6, and 4 spoke) at a speed of 70 km/hr. From the results of the simulation analysis, all modification of the cast wheel rim type was analyzed, obtained the value of the safety factor included in the safe to use category. Modified rim type cast wheel model A with the number of spoke 8 obtained the largest maximum voltage value that is equal to 1,372,E+09 N/mm
2, while for the smallest maximum voltage value obtained on rim model C with the number of spoke 4 which is 7,863,E+08 N/mm2 .


Keywords: Static Loading, rim modification, cast wheel, solidworks software


Full Text:

PDF

Refbacks

  • There are currently no refbacks.


Penanggung Jawab: Dekan Fakultas Teknik Universitas Halu Oleo

Pimpinan Redaksi: Aminur, ST., M.Eng

Mitra Bestari: DR. Akhyar, S.T., M.Eng.
Jurusan Teknik Mesin, Fakultas Teknik, Universitas Syiah Kuala, Banda Aceh 

Dr. Muhammad Syukron, S.T.,M.Eng. 
Jurusan Teknik Mesin, FakultasTeknik, Universitas Muhammadiyah, Surakarta

Dr. Eng. Sudarsono, S.T.,M.Eng. 
Jurusan Teknik Mesin, FakultasTeknik, Universitas Halu Oleo, Kendari

Dr. Eng. Lukas Kano Mangalla, S.T.,M.T. 
Jurusan Teknik Mesin, FakultasTeknik, Universitas Halu Oleo, Kendari

Dr. Eng. Nanang Endriatno, S.T.,M.T. 
Jurusan Teknik Mesin, FakultasTeknik, Universitas Halu Oleo, Kendari

Dewan Editor: Ir. H. Ridway Balaka,M.Eng.
Ir. Salimin, M.T.
Muhammad Hasbi, ST., M.T.
Budiman Sudia, S.T., M.T
Jenny Delly, S.T., M.T. 
La Hasanudin, S.S.T., M.T.
Raden Rinova Sisworo, S.T., M.Eng.
Prinob Aksar, S.T, M.T.

Penerbit: Jurusan Teknik Mesin Fakultas Teknik  

Universitas Halu Oleo
Kampus Hijau Bumi Tri Dharma Jl. HEA. Mokodompit
Anduonohu Telp.(0401)3194347.
e-mail : jurnal.enthalpy.uho@gmail.com

e-ISSN: 2502-8944